On the Properties page, you will see the option to Edit Community or Edit Floorplan:

Edit Community Info:

When you click the Edit Community button, this will take you to edit all community  info and photos. Note that all of this information will apply to all of your floorplans that are attached to this community. So this is the place to put all your community-wide information and photos- for floorplan specific stuff, hold off until you're editing a specific floorplan.

Next up are photos! To add photos simply drag them from your computer to the box that says Drag and drop or click here to browse...:

Note again that this is the place for all community photos- the building, fitness center, lobby, common areas, roof-deck, etc. If you have photos of specific floorplans, we will add those later. When your photo has been successfully added, a green check mark will appear below it, as in the above^. To remove a photo, click the X in the top right corner of the photo. To reorder them, click and hold to drag them one by one in the order you prefer.

Next are amenities! Check the boxes of any amenities your community has:

If your community has amenities that aren't on our list, you can add a custom amenity by clicking +Add below the appropriate section, typing your amenity name, and then Save. In this example, I've added one amenity and am about to add a second one.

Finally there is the leasing information:

For lease length, check all that apply, and if there are additional options or things to note, add it to the "leasing notes" section. Under application instructions, include the URL to where renters can apply and any other instructions, and renters will receive these instructions if they want to apply!

When you've entered in all the information, you can click Save Community on the left to save your community.

Edit Floorplan Info

When you click Edit Floorplan it will take you to the editing page for that specific photos. This is where you want to add any floorplan specific description or photos. The square footage, beds/baths, and floorplan name all populate from your PMS system- so if any of those are incorrect, you'll want to update them in your PMS.

When you are done adding/editing photos and a description, click Save Progress. This will update any active ads associated with this floorplan with the new info!

Did this answer your question?